Having same problem with 2 receivers
Maybe something came down the pipe for dreamlink
Having same problem with 2 receivers
Maybe something came down the pipe for dreamlink
Any ideas then for this coincidence?
Thanks
2 different setups!
I found that when I disconnect the Ethernet cable it boots. It will go into the reboots when Ethernet cable is connected.
Strange!
That same Ethernet cable works OK with a iptv receiver I have, so it cannot be that.
Last edited by booter; 03-31-2018 at 07:12 PM.
Tried another Cable ....still same problem.
Bummer
have you powered off and disconnected all cabled and powered on?
Yes. ...Usually a I can figure these problems out through process out through process of elimination.
Not this one.
You may have messed up the network part of the board if you were just taking the plug in and out with the receivers on.If use the same cable between iks and iptv. The only other thing you can try if you haven't yet is make sure it's plugged in and restart your whole network.
Hi
unplug network cable
receiver will boot up
goto where your setup servers
turn south off
and plug in network cable
turn receiver off and then back on and receiver should stay on
i have north also and all is working. There must be a problem with the south server