i found the best way to get all channels to scan in on a jynxbox is to do this :
the easiest way is the do a factory reset. then reset your setting for your sats . rescan all sats that you are using except for sat 110 and 119.
To get sat 110 back go to manual scan, change the first tp to the new mpeg4 setting by selecting edit tp red button on remote then change symbol rate from 20000 to 21500 and change the polarity to v then change Mode from QPSK TO TURBO then save . now you should see good signal on the first tp. Now go to the #2 tp and use the yellow button on remote and delete all the remaining tps just leave the first tp there .
Ones all the remaining tps are deleted hit the blue button on remote to scan then set network search to YES then hit ok and all channels will scan back in with good signal . now hit the side arrow on remote to get to sat 119
For 119 when your in the manual scan set to 119 sat, if the first tp has quality and strength , then leave the first one alone and delete all the rest of the tps for 119 then hit the blue button on remote set network search to YES then hit ok to scan and you will get all channels after your done go to tv channels in menu hit the blue button on remote to edit then hit red button on remote set to sort SELECT by SID exist and save . finished.
ps if you do not delete the remaining tps and set NETWORK SEARCH to YES you will get all double channels .
PLEASE Do NOT PM me for support! Post ALL Support questions in the forums for all members to benefit.