sat9182 north up/down

[dishuser]

On my unit under transponder all I have is (1/32) all the way up to (32/32). Am I looking in the wrong place because I dont see what you have listed. Menu/ installation/ Dish Setting. Also Ive been noticing that anytime you turn the reciever off or even go to the menu the reciever defaults to the same channel which it never did that before. Thanks for any help.

you should search or ask in the jynxbox section

[dishuser]

jynksbox is working dreamlink t5 no go yet

would a blind scan not pick up the changes?

[The Noof]

jynksbox is working dreamlink t5 no go yet

T5 & HD not responding to the transponder changes.Still no signal on the affected transponders.

[jets]

No signal on a Dreamlink HD or a VS Max. I tried blind scan and network scan on both.

Sat9182 you definitely have pic on the Jynxbox? I hope that incorrect because might mean bins are needed and that's not happening for the VS for sure and most likely not the DL either.

I have a jynx will test tomorrow...

[sat9182]

yes jynx working on all the tp's after change

i been playing with t5 with no successes yet

if you play with symbol rate you can get it good percent s and q but just will not lock and will not scan without a lock

[jets]

Thanks for the info. I will also dig out VS channel editor see if I can get anywhere. Anyone seen a DL channel editor?

Hope bins are not needed for effected boxes...