Results 1 to 5 of 5

Thread: Mag 254 blank screen

  1. #1
    Join Date
    Oct 2012
    Posts
    5
    Satfix Buxs
    262
    Thanks
    0
    Thanked 0x in 0 Posts

    Default Mag 254 blank screen

    Updated my mag.254 when it rebooted all I got is a blank screen.any ideas anyone?

  2. #2
    Join Date
    Mar 2016
    Posts
    2,228
    Satfix Buxs
    1,886,171
    Thanks
    4,703
    Thanked 7,939x in 1,581 Posts
    Items helicopter
Gift received at 01-04-2020, 04:43 PM from BluegrassTree
Gift received at 01-04-2020, 04:43 PM from BluegrassMonitor
Gift received at 01-04-2020, 04:43 PM from BluegrassGuitar2
Gift received at 01-04-2020, 04:43 PM from BluegrassACDC
Gift received at 01-04-2020, 04:43 PM from Bluegrass
Message: Just because lolSome beer
Gift received at 01-04-2020, 04:43 PM from BluegrassCrown Royal
Gift received at 01-03-2020, 04:57 PM from BluegrassCamaro
Gift received at 01-03-2020, 04:57 PM from Bluegrass

    Default

    c and p

    might be in pal mode
    To access Bios you have to unplug the MAG 254
    On the remote press the bottom left button near the arrows (3 dots/3 lines), press and hold and aim this at your mag

    plug mag in, that should bring you to BIOS

    I'm doing this off the top of my head right now.

  3. #3
    Join Date
    Oct 2012
    Posts
    5
    Satfix Buxs
    262
    Thanks
    0
    Thanked 0x in 0 Posts

    Default

    Got bias up what now,also thanks

  4. #4
    Join Date
    Oct 2012
    Posts
    6,822
    Satfix Buxs
    2,291,253
    Thanks
    7,338
    Thanked 12,328x in 4,234 Posts
    Items Crown Royal
Gift received at 11-09-2019, 09:07 PM from Putski
Message: Have a couple drinks on me..Sword

    Default

    if the issue is that your mag is in pal mode you need to change it to ntsc
    Dont have a mag so if it does not work you will have to wait for a mag user

  5. #5
    Join Date
    Dec 2017
    Posts
    200
    Satfix Buxs
    6,459
    Thanks
    409
    Thanked 274x in 134 Posts

    Default

    Try this and then if that don't work you can try and unplug the mags network cable let it boot up (give it a min or so).
    Then once you think it's been through boot process unplug it again put the network cable back in and try again.

    How to change the video on a mag
    If there is no image then complete next steps:

    If there is no image then complete next steps:
    Unplug power of STB
    Press and hold “Menu” button on RC (direct your RC to STB)
    Plug power on STB with holding “Menu” button
    Hold “Menu” button during 10 seconds.
    Switch PAL – NTSC with a single press on the red “F1” button.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •