t5 power adapter Blinking Green Light

[wirefox]

The light flashes on the power adapter and no power to the box, anyone ever have this happen?

[Gabacho]

Did you check the power adapter to see that it outputting voltage?

[wirefox]

Yes it's putting out voltage, tried it on T4 and worked

[nobodyspecial]

swap boards and see what happens

[wirefox]

Ok I'll try that Thx guys will post back with results

[auggie]

If it was the power adapter that came with your T5 (original) it will fail, This is a known problem with T4-5
get a new one off of Amazon,Ebay, that matches the specs and you should be Good-To-Go. Members here have posted
about this Known problem with T4-5.

[nobodyspecial]

If it was the power adapter that came with your T5 (original) it will fail, This is a known problem with T4-5
get a new one off of Amazon,Ebay, that matches the specs and you should be Good-To-Go. Members here have posted
about this Known problem with T4-5.

read post 3

[auggie]

read post 3

Yes I read it, but still could be the power adapter on it's way out ? it is the most common item that "WILL" Fail
which causes all kinds of problems with T4-5

[nobodyspecial]

if it works fine in the t4 then I doubt its the power supply
I know from your previous posts you believe replacing the power adapter is the solution to everything...lol

[auggie]

if it works fine in the t4 then I doubt its the power supply
I know from your previous posts you believe replacing the power adapter is the solution to everything...lol

When it comes to the DL-T4&5, the power supply and HD module are the most talked about problem, in that they fail
as well as the power board but it not as much. I have had to replace 2-power adapters on my T4's, was getting the
"No Signal" issue, as well as some channels quit working, and other issues, first I thought it was the HD module, swapped them out same issues, it was when i swapped out the power adapter everything was working.
Any ways I am only offering suggestions on what worked for me, anybody else can "TAKE-IT-OR-LEAVE-IT" ...lol

[dishuser]

When it comes to the DL-T4&5, the power supply and HD module are the most talked about problem, in that they fail
as well as the power board but it not as much. I have had to replace 2-power adapters on my T4's, was getting the
"No Signal" issue, as well as some channels quit working, and other issues, first I thought it was the HD module, swapped them out same issues, it was when i swapped out the power adapter everything was working.
Any ways I am only offering suggestions on what worked for me, anybody else can "TAKE-IT-OR-LEAVE-IT" ...lol

but
but
but










they already swapped...lol

[The Noof]

Yes it's putting out voltage, tried it on T4 and worked

I would try swapping the dl100/200 modules from t4 to t5 just for fun.Keeping that in mind, the power supplies can be an issue.There maybe different power requirements between the t4 & t5 that will allow the ps to work with 1, but not the other.

[Terryl]

If the T5 unit takes more DC current then the T4 unit, then the DC power adapter from the T5 that may be having a problem may work in the T4, but only if the overall DC current spec's for both are different.

A flashing green LED on a power supply may mean that it has a problem with the load, it has an internal problem, or it has taken an AC power surge and is in the protect mode, I don't have spec's nor schematics on the power supply so I am guessing at this point.

[nobodyspecial]

The t5 and t4 are identical except for software Terry

[wirefox]

Ok I'll try that Thx guys will post back with results

Changed the dl 200 but still not working thx everyone for the replies and help