Will a 8.0 UHF remote work with a 6131 receiver or is there a way to change the UHF to IR. Maybe switch the bottom piece over but I tried to take it out and it's not coming out any ideas or I just wasted money
Member
Question about remotes
Will a 8.0 UHF remote work with a 6131 receiver or is there a way to change the UHF to IR. Maybe switch the bottom piece over but I tried to take it out and it's not coming out any ideas or I just wasted money
Super Moderator
Try this;
Press and hold SAT until all 4 lights flash.
Press 2.
Press #.
SAT should flash 3 times to verify a valid code.
If this doesnt work then you need to check the menus to see what the remote address should be.
♫♫♫ I’m a lumberjack and I’m OK ♫♫♫ I drink all night and sleep all day. ♫♫♫
Coming soon to a crop circle near you.....
There is a 66 and third % chance that I'm on the right planet...
"I'm happier then a Jackalope in a balloon factory"
"First rule of testing satellites"
"If its working fine now, then don't mess with it"
"Second rule of testing satellites"
"If you did mess with it, and now it doesn't work, can you blame someone else?"
"Third rule of testing satellites"
"If you did mess with it, and it doesn't work now, and you can't blame someone else"
"Can you HIDE it"?
Member
I did that the remote number is 4 and I did exactly what you mentioned and pressed 4 instead of 2 and it flashes 4 times I save it and it doesn't operate the ird so I'm out of option
Posting Permissions
Reply With Quote
