Originally Posted by
surveyor1951
I found what the problem was, it was the power adaptor on the T4. I tried the t5 adaptor on the T4 & it ran a lot better on the transponders. I reinstalled the DL200, I found one my older power adaptors that had 12 volts & 2.5 amp. It now runs as it should. I hooked up my SW21's to my receivers, I am getting the 91 satelite (showing in blue in the mid 80 range, but my 82 satelite , is showing red but showing in the high 80's & low 90's. I have the right skew set on my dish for my region but there are quite a few trees where I live. This is the best place to install my dish, any lower I would be in all the branches. Any ideas why my 82 sat is showing red but it is showing a good signal even though it is showing red. Thanks for all the advice, I was able to solve one of the problems.