I keep loosing signal on 91w worked ok for a while now most lower v polarity in lower # tp stopped working-no signal
boot loader 2.07 main software hd20 front software vb07 setings are rite new power supply new quad lnb changed wires
I keep loosing signal on 91w worked ok for a while now most lower v polarity in lower # tp stopped working-no signal
boot loader 2.07 main software hd20 front software vb07 setings are rite new power supply new quad lnb changed wires
Are you watching the 82 as well?If so, remove the 8psk &go through the factory tuner.
yes it seems when I get one sat ok the other one looses half the transponers
so hooked up another box with no hd module same problem
have anew dp+ quade on port 1 most horizontal transponders work but no V
hooked to the dish with no switches any ideas ????
sym 20000
pol h works q 100
v nosig
Fec auto
mode QPSK
Thanks I am going nuts 2 days now
lb type ocs-dp
freq 11250
diseqc off will work on 1 also
legacy switch off
Last edited by guy; 03-08-2020 at 07:31 PM.
to what it now OCS_DP
Legacy off
tried lots off combination this is the only one that works
try 91 port 1
82 port 2
diseq on for both sats
For the transponder not coming in, create a new one with same number and change horizontal to vertical or vertical to horizontal and check quality on signal.
when you change the vertical to hor or auto shows 97 quality but when you go to chanels show no sig just like it was setup before
no signal on vertical chanels I have two boxes 8000s both the same tried 3 diferent lnbs two new
post your settings using dp quad
DODGE the father
RAM the daughter
“Always do sober what you said you'd do drunk. That will teach you to keep your mouth shut.”
Now have a 1000.2 lnb set up 91 Diseqc port1
82 Diseqc port 2
same thing happening
try switching ports just in case
DODGE the father
RAM the daughter
“Always do sober what you said you'd do drunk. That will teach you to keep your mouth shut.”
When you get quality after change to hor, you can do a scan on the transponder.