Does anyone runs USALS on Ku band using a HHmotor with a Dreambox?? Thanks
Does anyone runs USALS on Ku band using a HHmotor with a Dreambox?? Thanks
Yes but problem is the setup is not ideal.
It's done using a switch or in my case I have dual tuner. I run ku on second tuner but first issue disec cmd before going to the ku folder so the box goes to second tuner so the dish moves if need be. I use 2 folders for each position, 1 c , 1 ku per satellite.
Running straight to the motor or do you have switches in the line ?
I'm running both C and Ku on a Dreambox with 22khz switch high side driving the Ku section, with a Diseqc and 4x2 multiswitch in line. Running without problems so it can be done.
You should only have to enter your lat/long one time ? How/why are you entering it for each sat ?
Very good.
Here:
Last edited by cpr43; 05-04-2020 at 06:38 PM.
Try setting Diseqc 1.0 Command to "None" and maybe turn off "Use Power Management" if that's related to Power Threshold in ma (I don't have that one in my tuner settings) The motor needs current to drive the dish maybe that is set too low for it.
Last edited by zayden; 05-04-2020 at 11:56 PM.
By the way which Dreambox is this and what image are you using ?