Results 1 to 4 of 4

Thread: DM500-s troubles: network/pin/password/serial port

  1. #1
    Join Date
    Mar 2021
    Posts
    11
    Satfix Buxs
    50
    Thanks
    1
    Thanked 0x in 0 Posts

    Default DM500-s troubles: network/pin/password/serial port

    My DM500-s started having issues after a power outage - it's continually dropping network packets.

    I went out and found two used DM500-s, and now have other issues with these:

    1. don't know the PIN - so I can't change the settings
    2. telnet/ftp/ssh password seems to have been changed so I can't get access that way.
    3. dreamup doesn't see the box at power up.
    4. attempts to use the serial console have been frustrating:
      - at 115200, 8,N,1, with no flow control or with Xon/Xoff
      - I only get jibberish at the console at power up
      - I read a post somewhere that said to repeatedly press the X key at startup in the console, then enter:
      Code:
      "console=null root=/dev/mtdblock5 rootfstype=squashfs ro console=ttyS0,115200 single"
      . That actually turned the display into something readable until it gets to the point where busybox starts, then I get jibberish again and cannot proceed.


    As such I now have two more dreambox paperweights. Anyone have any further ideas? I'd prefer to not JTAG, but can if I must....

  2. #2
    Join Date
    Mar 2017
    Posts
    2,066
    Satfix Buxs
    3,237,915
    Thanks
    315
    Thanked 5,172x in 1,377 Posts

    Default

    dm's are old better off to use one of these for what you are using the dm for


    Code:
    https://shop.tbsdtv.com/tbs3102-5-crystal-phoenix-or-smartmouse-card-reader-p-179.html
    #1 Source for North IKS. For IKS Visit our website to order: sat9182.xyz
    For Wickediptv Visit our website to order: wickediptv.com

  3. The Following 2 Users Say Thank You to sat9182 For This Useful Post:


  4. #3
    Join Date
    Mar 2021
    Posts
    11
    Satfix Buxs
    50
    Thanks
    1
    Thanked 0x in 0 Posts

    Default

    I considered that, I can run rqcs on a PC, but I would still need to feed the card the EMM/ECM for updates....none of my FTA boxes (dreamlink/jynxbox) send them....I presume I would need a DVB-S2 PC card and use rqcamd as well?

  5. #4
    Join Date
    Oct 2024
    Posts
    2
    Satfix Buxs
    9
    Thanks
    1
    Thanked 1 Time in 1 Post

    Default

    For the Telnet/FTP/SSH access:
    The default credentials are usually:
    username: root
    password: dreambox

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •