dreamlink T5 91/82 EPG.. 2 Questions

[auggie]

yes 1 dish with a dual bev legacy and 2 separate Dishes with single circular lnbs .. no name visible single lnb. They are real close and I run 4 cables to a outside 4 x 1 DiSEqc then single cable to the unit inside the house. No more then 3m of cable.

The T5 alone doesn't have the required power to run all that by itself, that's why I/Noof suggested the powered SW-44 WITH
Inserter, you could try hooking up a Bell/dish receiver as well to the equation, so as to help power things possibly ?
Most likely what you are running into because for Lack of power is switching issues between the Sats.
It's all Power related

[dishuser]

get a dlhd
I ran 5 sats off mine

[The Noof]

yes 1 dish with a dual bev legacy and 2 separate Dishes with single circular lnbs .. no name visible single lnb. They are real close and I run 4 cables to a outside 4 x 1 DiSEqc then single cable to the unit inside the house. No more then 3m of cable.

I think you may have sourced your problem...I would still try a no-sat state for test purposes.

[dsd]

I think you may have sourced your problem...I would still try a no-sat state for test purposes.

I will give this a try

[dnasp002]

A SW-44

One like this if Legacy LNB's : hxxps://www.ebay.ca/itm/183815161227?hash=item2acc3cc58b:g:8rUAAOSw4AJcc3H 6

Have a look here: hxxps://www.canadasatellite.ca/Bell-Legacy-Switches-s/3272.htm

the sw44 is for 2 satellites
he would need 2 of them and some way to combine the 2 switches
I suppose a 22kz would work to switch between the 2 sw44

[dnasp002]

yes 1 dish with a dual bev legacy and 2 separate Dishes with single circular lnbs .. no name visible single lnb. They are real close and I run 4 cables to a outside 4 x 1 DiSEqc then single cable to the unit inside the house. No more then 3m of cable.

I should have read this before I replied

you can only use an sw44 on the BEV dish

if the other lnbs are actually singles, a sw44 requires 2 dual lnbs

did your system ever work properly with the diseqc switch ... if so then I would disconnect the ports one at a time and see if your problem is an lnb

it's not uncommon for an lnb to draw too much power when it's failing

[dsd]

Just to let you all know ,It seems the issue was with my DL and not setup, I just picked up a other DL and it works perfect even now with cooling fan , No reboots at all. Like I said earlier in first post when the cooling fan was on top of it, it would reboot every minute it was on so I figure a bad connection some where in the board that the tiny vibrations messed it up.But a newer DL and problems are gone...Thanks all that had a input,great ideas to look at for sure .