well i want to say thank you to auggie for helping me and telling me what to do and try. i want to report that doing the factory flash and system clean up over six times did the trick.
well i want to say thank you to auggie for helping me and telling me what to do and try. i want to report that doing the factory flash and system clean up over six times did the trick.
well the UD error came back after two weeks and i didnt Pay any attention to it and set it aside and went back to my T5. but last week i wanted to use my SV8000 again to only remember that UD error was still there so i buckled down and wasn’t going to give up this time to fix it for good. i had help the whole time from Auggie and stayed by my side through it all with me. the problem was the 2028 file wasn’t working for me and kept getting the UD error and then finally Auggie uploaded a newer 2028 file and bam it all worked out and is working stronger then ever and i am very greatful for having Auggie by my side and lots of thank you goes out to him thank you thank you.
again to everyone that’s on this site helping and paying it forward thank you so much for everything
Is the file @auggie posted considered the "latest" file for hd 8000? And it doesn't need SVLan or iHUB adapter? I want to update my receivers
i use the wiz board i feel they work better and last longer. i used the new 2028 file auggie uploaded and that worked for my UD error
Sorry , meant which file is considered latest as in has the newest firmware etc. Sounds like the 2028 file is what was last made?
BTW I don't remember anything about a wiz board. I do have either a svlan or ihub sitting around from years ago.
Can someone shed some details on what it is? lol
It is one of these:hxxps://www.digikey.ca/en/products/detail/wiznet/WIZ110SR/3829651
Ethernet Adapter etc. similar to the IHub, which are still available I believe (wiz-board)