EPG channel is not exist

[jets]

No I can't post pictures. Use manual scan and edit TP 12428 on sat 91 as Trurbo8PSK, 2/3 FEC, then hit red button.

[peterpeete]

Hello, when you write edit TP 12428 on sat 91

the TP do you mean set, the name is it Frequency and set to 12.428 ghz (V)

Impossible to scan nimiq 91 no channels found,

Just one thing I use a spliter is it a problem, does I scan with no splitter, directly to nimiq 91

Thank you...

[jets]

You mean you use a switch?

Go Menu > Manual Scan > Select satellite 91.0W > change frequency to 12.428 >change symbol rate to 21.500 by typing in numbers > scroll down to Transmission and change the mode to TURBO 8PSK. Then hit the red scan button. You will now have a few channels with guide if you sit on that channel for 5 minutes. One channel is 1199 or just 199 NTV.

[dsd]

Jets Thanks a lot for this post My go to channel was 1199 for EPG, then it went away. Saw your post and changed symbol rate to 21.500 by typing it in and just exited the screen and now 1199 is working again...TP #13 and 14 work for 21.500ms ...Thanks

[peterpeete]

Hello DSD,

Yes very good I retreive 1199 and some channels to nimiq 91,

Is it possible to have more channels...

Thank you...

[auggie]

Hello DSD,

Yes very good I retreive 1199 and some channels to nimiq 91,

Is it possible to have more channels...

Thank you...

Have you made the changes to TP's 1-thru-19 yet, if not you need to do that for Some channels to come in/back

[beefcake]

Hi i can change the TP but when i go to change the symbol to 21500 it says same TP exist try again i like to get 1199 also thanks

[auggie]

Hi i can change the TP but when i go to change the symbol to 21500 it says same TP exist try again i like to get 1199 also thanks

You need to change the Pol also, H or V and for some the Fec=3/4 or 3/4A

I believe the Dreamlinks are Toast, because it can't handle the TP changes, especially the FEC to 3/4A

No such setting/item in the software/firmware etc.

[jets]

You need to change the Pol also, H or V and for some the Fec=3/4 or 3/4A

I believe the Dreamlinks are Toast, because it can't handle the TP changes, especially the FEC to 3/4A

No such setting/item in the software/firmware etc.

The dreamlinks are fine on 82 and the 91 TP transponder, all that is needed to get HD channels with guide.

[dsd]

This is what I did...Went Menu then Manuel scan, Fist one 91wNimiq 1, Frequency 1 thru 32 and changed each TP to Symbol rate to 21500 ms by using remote to manual type new MS rate in. then transmission rate to Turbo 8PSK on all 32 TPs and Fec to auto. Just exit and it will save all changes for you.

[auggie]

Only TP's 1-thru-19 need changing to 21500 Turbo 8PSK Fec=3/4A

On Lynsat TP's 20-thru-32 are set at 20000 DVB-S Fec=7/8 ?