Junxbox Premium HD Info/Pictures/"Review"

**peterpeete** · 11-16-2024, 11:21 PM

Hello,
I check the Junxbox Premium HD and NO USER MANUAL, it's very complicated for a new,
does anybody have it...

I have a splitter one on sat 91 and the other nimiq 82, no problem to scan nimiq 82 but nothing to nimiq 91...

I found channels but Black Screen no picture to nimiq 82...

I connect the cable of internet in to the receiver the signal is good, not wi fi...

I check
Menu,
Tools Network Local Setting
and I set DHCP ON
I see the ip adress with 4 group it,
I see subnet mask with number,
I see gateway with number,
I see dns preferred with number,
I see dns alternate with number,
Everything seems ok

I click to Apply and I have a message to indicate Apply Network local setting.

Serving setting (bug).
After I go to serving Setting
I see 8 ip adress.
I take the number 1 and I'm enter protocol: CcCam
Ip/Name: the same of dreamlink
Port: the same of dreamlink
Password: the same of dreamlink
DESS Key: the same of dreamlink
Apply: Connection Failed

I don't undersdand I check to dreamlink and it's correct but not to JunxBox....

Does anybody know What Is The Problem...

Than you very much...

**peterpeete** · 11-29-2024, 06:41 PM

Hello,

I tried that and I don't remember the result but reading in the forum, someone spoke
to reset the modem and the router and I tried with the router only and it didn't work,

I also tried by turning on the wifi only by removing the dhcp without the wired network connection and it worked
but had to enter Alternate on 008.008.004.004 in the dhcp. On the other hand, it still blocked him,

a power outage happened by chance and it reset my modem and router (they are separate) and i left
wifi and dhcp activated at the same time and since then except for a few outages it has been working,
I have an old router and connects at 60%

I think a more powerful router would help.

Other Problem.

The VPR.

I tried to format a 32 G USB key in fat, ex fat and NTFS, it worked for about 1 minute and then everything froze.

I ordered UGREEN Hard Drive Enclosure 3.5 2.5 Inch SSD Enclosure, USB 3.0 to SATA HDD Case with 12V Power Adapterun external enclosure empty UGREEN sata usb 3 (the junxbox is in usb 2) which can contain a 500 G hd. sata hoping that it works but I have
no manual and the manufacturer told me it was sold without a manual...

Could you help me and tell me for the VPR what you know...

Remote
Also no manual if you know where to find it...

Thank you, also if you know the owner of the site could you ask him to put a thread on this receiver because
it's not easy to find...