trying to get a T5 going, when powering up all it does is blink the red&green lights and looks like 8's on the display blinking? Cannot get it to do anything, is it now a brick or what? Any help or suggestions would be appreciated, thanks...
trying to get a T5 going, when powering up all it does is blink the red&green lights and looks like 8's on the display blinking? Cannot get it to do anything, is it now a brick or what? Any help or suggestions would be appreciated, thanks...
Last edited by dinger; 06-18-2022 at 03:33 PM. Reason: spelling errors
DODGE the father
RAM the daughter
“Always do sober what you said you'd do drunk. That will teach you to keep your mouth shut.”
thanks, tried that and never changed anything?? same as b4 just flashes.....
might sound stupid but did you change the power adapter ? i've went through i bet at least 10 between friends and myself.
Have you checked the external power supply???
If it's too weak (under 12 or more volts DC) to power up the receiver then you could get what your seeing.
Last edited by Terryl; 06-18-2022 at 06:49 PM.
Looks like Scooby8888 and I are on the same page, try this, disconnect the coax from the LNB (with the receiver off, this will drop the DC current draw from the power supply) and see if it will boot up. If it does then your power supply is pooched.
Try disconnecting the coax coming down from the LNB, if there is some sort of short or excessive current drain it may cause this.
OK, Take the HD Module out, disconnect ALL CABLES, and Reload/Flash with Boot Loop file using null cable & loader program
You "MAY" need to do it more than once, also reading from other forums some have had success pulling the power as the
T5 BOOTS up, to access the menu etc. If you get T5 to function (no boot-loop) I would load factory file followed by latest bin
doing a Hard shut down (back switch) between each load.
What are the Specs on the Power Adapters you are using, if under 3 AMPS, not enough power
You need one that's 12v 3.5-5amp for the T5 to run/operate correctly depending on all the equipment
it needs to feed power to (LNB's Switches, HD Module, etc.)
Try & get one with a little more jump to it 3.5-5amp if you can