New user question

[Tonysichareune]

hi,i have neosat 2000 pro and would like to connect to iks,can some one help?thanks

[StanW]

hi,i have neosat 2000 pro and would like to connect to iks,can some one help?thanks

Instructions/factory file can be found here :

• Neosat/Nuesat Pro/iPro 2000/Ipro 2000+ Files
  
  

[Tonysichareune]

Thanks,standW I neet help to set up nfps on my neosat 2k,I have the file but I don't know how can u tell me step by step thanks agian

[ICEMAN]

tony you have the files but you need help to load it into your receiver?
here are some instructions on how to..hope this helps ya.. good luck bud..

http://www.satfix.net/showthread.php...00-Setup-Guide

[StanW]

Thanks,standW I neet help to set up nfps on my neosat 2k,I have the file but I don't know how can u tell me step by step thanks agian

Once you have loaded file 4.30 to your receiver using the guide (see link in my post above) and configured your sats you will have to create a file named newcamd.conf which will be saved to your usb stick.
The file has to look like

#
# newcamd 
#

CWS = aaaaaa bbbbbbb username password 61 03 40 34 45 40 69 70 98 71 23 41 21 34 wan cardserv

aaaaaa is the ip (or domaine) bbbbbb the port ,username and password were sent to you by nfps.

The CWS line can be repeated for additional p$ (or the same one with different ports or ip/domain ) - your receiver can connect to up to 10 servers simultaneously.
Insert the usb stick into your receiver,open the sliding door on the remote and hit f1 followed by read. Hilite the server you want to use an hit the appropriate connect button.

Edit : complete guide to newcamd is available here

http://www.satfix.net/showthread.php...401#post957401

[Tonysichareune]

Thanks,stanw for ur help but I have question about new camfile,when I open it with notepad but I can not read,any idea?

[StanW]

Which newcamd file ? If you're trying to modify the one from the file section you have to unzip it prior to editing. If ,on the other hand , you are creating your own from scratch than you have to create a .txt file and save as .conf when done.

[Tonysichareune]

Thank,stanw.i will try this weekend