slb
11-11-2013, 09:08 PM
I have searched for answers on this.
I am using a dish 500 and 300 (legacy LNB) with a new Chieta wsd-2041 switch but it's doing the same thing as my cheap switch. This Chieta switch does not have the part numbers stamped so I emailed Phat Satellite and he says the switches are legit without P/N. I dont know...
If I scan 119 it will show 119 at the top before scanning but if I scroll down to a different transponder I see 110 at the top. This is scanning manually and 119 individually without the 110 lnb even hooked up to the switch. So is it a switch issue or is it an LNB issue with my Dish 500?
I have done factory resets and my ports are all set correctly (119 port 1, 110 port 2 and 129 port 3) with disceq set to the proper port, everything else off.
No matter what I do I get duplicate channels on many of the channels. I was using a Dish 1000.2 but the power hog was put away for this set-up. I shortened the length of my rg6 cables by half (about 60ft total) and this has improved my signal greatly. No more problems with the jynxbox.
Wonder if someone can post their userdb file with all the correct channels as they should be then maybe I can use that to solve the issue. Either that or get yet another switch or swap out the Dish 500 LNB. Duplicate channels and many channels are blank as a result (wrong sat when tuning in the channel obviously) Any advise would be appreciated.
I am using a dish 500 and 300 (legacy LNB) with a new Chieta wsd-2041 switch but it's doing the same thing as my cheap switch. This Chieta switch does not have the part numbers stamped so I emailed Phat Satellite and he says the switches are legit without P/N. I dont know...
If I scan 119 it will show 119 at the top before scanning but if I scroll down to a different transponder I see 110 at the top. This is scanning manually and 119 individually without the 110 lnb even hooked up to the switch. So is it a switch issue or is it an LNB issue with my Dish 500?
I have done factory resets and my ports are all set correctly (119 port 1, 110 port 2 and 129 port 3) with disceq set to the proper port, everything else off.
No matter what I do I get duplicate channels on many of the channels. I was using a Dish 1000.2 but the power hog was put away for this set-up. I shortened the length of my rg6 cables by half (about 60ft total) and this has improved my signal greatly. No more problems with the jynxbox.
Wonder if someone can post their userdb file with all the correct channels as they should be then maybe I can use that to solve the issue. Either that or get yet another switch or swap out the Dish 500 LNB. Duplicate channels and many channels are blank as a result (wrong sat when tuning in the channel obviously) Any advise would be appreciated.